| Author |
Message |
thompson_2986
Joined: Wed Sep 03, 2008 11:30 pm Posts: 80 Location: Allambee
|
 Posted: Sat Jan 22, 2011 10:35 pm |
|
|
Hey zookers,
As the subject states I'm looking at purchasing transfer gears from low range off road and deciding between the 4.9 or 5.14 (calmini).
I was wondering about experiences people have had with this gears and whether is is worth spending the $100 more for the Calmini gears.
I am currently running 30inch wheels and will be upgrading to 32's in the near future so i believe 6.4 are to low for me.
Any help will be appreciated.
Thanks Tom
|
|
|
|
 |
Rusho

Tubby Elfsdong
Joined: Sun Aug 02, 2009 11:30 pm Posts: 6501 Location: Northside, Brisbane
Vehicle: Coily Sierra
|
 Posted: Sat Jan 22, 2011 10:53 pm |
|
|
6.5's and 32's would be fine mate
_________________ Shep is a closet jimny lover!!!!
|
|
|
|
 |
Red89
Joined: Tue Jan 12, 2010 10:30 pm Posts: 2801 Location: Perth
|
 Posted: Sat Jan 22, 2011 10:56 pm |
|
|
I have had the 5.14's now for 5 years or so, they have been given hell using the stock mounts and no TC ring and they have been bulletproof, personally they are good for up to 31's but 32's will be pushing it and you may end up wishing you went for 6.5's. What sort of wheeling do you mainly do ?
|
|
|
|
 |
Fatzook

az supporter
Joined: Sat Oct 27, 2007 11:30 pm Posts: 14977 Location: The Hills
Vehicle: Vitara, NGV
|
 Posted: Sat Jan 22, 2011 11:23 pm |
|
|
If you went for the 5.14's now, you could always change your diff ratios later to help with the 32's.
_________________ 2013 GV 1998 SV420 ute
|
|
|
|
 |
Teracis
Joined: Sat Dec 11, 2010 10:03 pm Posts: 2261 Location: Gold Coast
Vehicle: Daisy
|
 Posted: Sun Jan 23, 2011 12:23 am |
|
I am ordering 6.5's and I am running 29's, I'm planning to go to 31's and I'll get a spare stock tcase in future (for if I decide to go on a looong trip) but I can get away with it because I do basically zero highway driving. I worked out all the ratios and speeds with this site Gear Ratio Calculator and I came up with about 3800-4000 rpm with 6.5's and 31's in 5th high at 110km/h
Which isn't too bad because at the moment to go that quick and maintain it I have to use 4th gear anyway which sits in exactly that rev range.
Also, I'm pretty sure the trail creeper gears have better warranty than the calmini's.
|
|
|
|
 |
shane1992

az supporter
Joined: Tue Jun 08, 2010 10:09 am Posts: 782 Location: Wollongong
|
 Posted: Sun Jan 23, 2011 1:46 am |
|
|
Transfer case gears, dont they only effect the high and low range whilst in 4WD ? So why would it effect 'highway' driving? You wouldnt have it in 4wd.
These transfer gears f#@king confuse me, I havent been given a straigh answer if they effect 2wd
|
|
|
|
 |
CairnsZook

az supporter
Joined: Tue Jul 18, 2006 11:30 pm Posts: 872 Location: West Coast
Vehicle: Zookless
|
 Posted: Sun Jan 23, 2011 2:13 am |
|
Fatzook wrote: If you went for the 5.14's now, you could always change your diff ratios later to help with the 32's. This is what I'll be doing (with different ratios though). Should "spread the load" a little throughout the drivetrain. shane1992 wrote: a straigh answer if they effect 2wd
YES 
|
|
|
|
 |
bazook

az supporter
Joined: Sat Jul 12, 2008 11:30 pm Posts: 1082 Location: brisbane logan
|
 Posted: Sun Jan 23, 2011 8:45 am |
|
|
i have 32s and 6.5.1 and use from third gear up there a little to low for stuff we have here
_________________ josh AKA Bazook
|
|
|
|
 |
thompson_2986
Joined: Wed Sep 03, 2008 11:30 pm Posts: 80 Location: Allambee
|
 Posted: Sun Jan 23, 2011 8:53 am |
|
|
I mainly drive my zuks on the weekend and in steep muddy/clay areas so i think the 5.14 and then diff gears sounds the better option.
Thanks a lot guys
|
|
|
|
 |
suzi-fan-22
Joined: Tue Nov 09, 2010 9:31 am Posts: 499 Location: Ipswich
Vehicle: Sierra Ute '87 Sj70
|
 Posted: Sun Jan 23, 2011 9:14 am |
|
|
what do you guys recomend for 30s but future 32s but daily 50-80ks at 110 k/ph driving?
_________________ It's all coming together 
|
|
|
|
 |
|