[zookprojectfnq]

I broke a uni joint in half a bent up the yoke on the tail shaft. I decided enough is enough and decided to build a heavy duty model.
I used the small ends off 2 80 series tail shafts and cut the tube down.

The bolt pattern is the same except the spigot is 1mm smaller and the pinion nut hits. So I pulled the yokes apart and machined them out. I also machined the tube down and weld prepped it for a yoke to spigot in.
now runs cruiser uni joint which are 29 mm instead of the 25mm suzuki ones.. Cruiser tube is 70mmwith a much bigger and longer spline, Suzuki is 50mm
If I break this one I will have serious problems!

[dank]

haha PHAT! Nice work.

[FullyZooked]

I'll take 2 thanks...

[Fatzook]

Haha great minds think alike

Mine should be done by thursday

[dogbox]

make it to strong an something else will break that could be more expensive to fix

[steak_knife]

dogbox wrote:

make it to strong an something else will break that could be more expensive to fix

yep!!!

[steak_knife]

Good work tho, like the lil roller thingy..

[3cyl]

Did it break from axle wrap?