[rick1970]

Part way through making a swingout wheel carrier and thinking about adding a jerrycan holder on there as well.

Had a look at the pre-made holders at ARB and supercheap. Are these any good? Do they hold up to rough roads, as they look a bit om the flimsy side to me. Would i be better of just making one from scratch?

Cheers
Rick

[Fatzook]

Hi Rick. I've used a few of the TJM ones with great success.

[buzbox]

Fatzook wrote:

great success.

sorry couldn't help it..

The ARK jerry holders are pretty much the same, they do the job, but maybe hit them with a few extra coats of paint to prevent rust in the corners and where the steel joins together.

[Navy_mike]

Any photos of the work in progress??

[rick1970]

Still gotta add a latch, jerry holder and paint. Will be moving number plate and light to rear of jerrycan holder.