[turbo_deo]

I searched but didn't find anything, the transfer arms I got from a wrecker for my rockring, the log arm has big holes where the rubber mounts bolt up to instead of the 3/8? Hole and smaller locating hole, would it be safe to weld a plate in and drill the holes that I need?

[steak_knife]

Yes, while you have the glue gun out brace the rest of it to..

[turbo_deo]

Yea got some dimples dies that should be here next week and roctoy ring is going on at the same time

[Teracis]

shit that reminds me to find a place to get a roctoy from!

Dimple dies as in for making sheets stronger? (thanks google) is that for your plate you're planning to weld over the holes?

[turbo_deo]

Yea dies to make the sheet stronger, using them because they are super cool and so I can brace my ring to the arms with 3mm plate and still keep it strong, the bigger holes will just be plated glued then re drilled with the right holes