| Author |
Message |
boostedbrick

az supporter
Joined: Tue Jun 29, 2010 7:44 am Posts: 2003 Location: Brisbane
Vehicle: 2018 DMAX
|
 Posted: Sat Apr 02, 2011 1:06 am |
|
Have the following. 2pin WT center.. Needs bearings. $80
22spline WT CVs/axels $50(make an offer  ) Only long side left
Clutch, aftermarket replacment. Alot of meat left on the clutch plate, good pressure plate.. USED, $50
G13a, no carby or alt. But otherwise complete. Good for parts. Has new fuel pump.. Bottom end is shagged. Any parts off it are free.. Has sump/pickup
WT fuel tank.. Very minimal dints,(still be 39liters), tiny bit of rust staining inside, will need flush. $ sold...
WT tow bar, some rust needs paint. $30
Brand new webber 32/36 $150.. Brought new back in '02 for 320.. sat on a shelf since.
G13A/B rocker cover gasket.. cork... Free
Left hand door, damaged with good glass. Free
G16b dizzy.. No cap/button. $40
Pick up only. Browns plains way.. open to offers..
Last edited by boostedbrick on Sun Apr 03, 2011 2:51 am, edited 1 time in total.
|
|
|
|
 |
tonyevans

az supporter
Joined: Sun Jan 16, 2011 11:18 pm Posts: 1998 Location: Lightning Ridge NSW
Vehicle: SJ40 - LJ50 - LJ50V - Vitara
|
 Posted: Sat Apr 02, 2011 1:21 am |
|
|
Does the Webber have a Suzuki adapter? Will you post to western NSW?
|
|
|
|
 |
boostedbrick

az supporter
Joined: Tue Jun 29, 2010 7:44 am Posts: 2003 Location: Brisbane
Vehicle: 2018 DMAX
|
 Posted: Sat Apr 02, 2011 1:27 am |
|
|
Doesnt have adapter... Brought it before i had a sierra.. If your still keen your looking at around $20 postage to Dubbo..
|
|
|
|
 |
reallyuted
Joined: Fri Nov 14, 2008 10:30 pm Posts: 253 Location: jimboomba se QLD
|
 Posted: Sat Apr 02, 2011 3:17 am |
|
|
i only need the short side axel with cv if you want to sell them seperate? how much cheers
|
|
|
|
 |
lump_a_charcoal

az supporter
Joined: Wed Feb 28, 2007 10:30 pm Posts: 4454 Location: Botany, NSW
Vehicle: MY2019 Jimny
|
 Posted: Sat Apr 02, 2011 6:27 am |
|
tonyevans wrote: Will you post to western NSW?
Yes he will!
|
|
|
|
 |
boostedbrick

az supporter
Joined: Tue Jun 29, 2010 7:44 am Posts: 2003 Location: Brisbane
Vehicle: 2018 DMAX
|
 Posted: Sat Apr 02, 2011 6:44 am |
|
reallyuted wrote: i only need the short side axel with cv if you want to sell them seperate? how much cheers
If theres no interest in both in a few days ill let you know.
|
|
|
|
 |
boostedbrick

az supporter
Joined: Tue Jun 29, 2010 7:44 am Posts: 2003 Location: Brisbane
Vehicle: 2018 DMAX
|
 Posted: Sat Apr 02, 2011 6:45 am |
|
|
|
 |
Bruce

az supporter
Joined: Sun Jun 11, 2006 11:30 pm Posts: 4003 Location: Brisbane
|
 Posted: Sat Apr 02, 2011 6:46 am |
|
|
Where abouts in Brisbane are you mate?
_________________ [quote="royce"] I wouldnt mind insulating my rear
|
|
|
|
 |
boostedbrick

az supporter
Joined: Tue Jun 29, 2010 7:44 am Posts: 2003 Location: Brisbane
Vehicle: 2018 DMAX
|
 Posted: Sat Apr 02, 2011 6:47 am |
|
|
|
 |
Bruce

az supporter
Joined: Sun Jun 11, 2006 11:30 pm Posts: 4003 Location: Brisbane
|
 Posted: Sat Apr 02, 2011 6:48 am |
|
Thanks. Can never have enough CV's but bit too far for them. 
_________________ [quote="royce"] I wouldnt mind insulating my rear
|
|
|
|
 |
royce

omnipotent being
Joined: Sun Jun 11, 2006 11:30 pm Posts: 17216 Location: Pluto
|
 Posted: Sat Apr 02, 2011 7:01 am |
|
Bruce wrote: Thanks. Can never have enough CV's but bit too far for them. 
I knew youd be in here soon enough sniffing out cv's 
|
|
|
|
 |
Bruce

az supporter
Joined: Sun Jun 11, 2006 11:30 pm Posts: 4003 Location: Brisbane
|
 Posted: Sat Apr 02, 2011 7:16 am |
|
royce wrote: Bruce wrote: Thanks. Can never have enough CV's but bit too far for them.  I knew youd be in here soon enough sniffing out cv's 
You think I have enough, don't you 
_________________ [quote="royce"] I wouldnt mind insulating my rear
|
|
|
|
 |
boostedbrick

az supporter
Joined: Tue Jun 29, 2010 7:44 am Posts: 2003 Location: Brisbane
Vehicle: 2018 DMAX
|
 Posted: Sat Apr 02, 2011 7:30 am |
|
Its only an hour here from the northside Bruce.. or 2 in traffic 
|
|
|
|
 |
Bruce

az supporter
Joined: Sun Jun 11, 2006 11:30 pm Posts: 4003 Location: Brisbane
|
 Posted: Sat Apr 02, 2011 7:37 am |
|
True mate I know 
_________________ [quote="royce"] I wouldnt mind insulating my rear
|
|
|
|
 |
reallyuted
Joined: Fri Nov 14, 2008 10:30 pm Posts: 253 Location: jimboomba se QLD
|
 Posted: Sat Apr 02, 2011 9:25 pm |
|
|
|
 |
boostedbrick

az supporter
Joined: Tue Jun 29, 2010 7:44 am Posts: 2003 Location: Brisbane
Vehicle: 2018 DMAX
|
 Posted: Sun Apr 03, 2011 2:52 am |
|
|
Open to offers... This stuff aint any use to me around here.
|
|
|
|
 |
fatz
Joined: Mon Sep 14, 2009 11:30 pm Posts: 152 Location: tasmania
|
 Posted: Mon Apr 04, 2011 5:14 am |
|
|
do you have a flywheel by anychance?
|
|
|
|
 |
boostedbrick

az supporter
Joined: Tue Jun 29, 2010 7:44 am Posts: 2003 Location: Brisbane
Vehicle: 2018 DMAX
|
 Posted: Mon Apr 04, 2011 7:10 am |
|
|
|
 |
|