[xedent]

How would you re inforce the chassis mounts not using out riggers ?

[zooky08]

That's what I run
Oi fatzook how much would i be looking at for some one to cut my mounts off and weld two more new ones in

I'm thinking of doing shep mounts but I'll new new bar mounts

[zooky08]

xedent wrote:

How would you re inforce the chassis mounts not using out riggers ?

The best I would think is shep chassis mounts

[remydog05]

xedent wrote:

Just got a Arb winchbar for my Sierra and just wondering what winches fit in it other than the warn ones.

Cheers

Also after some pictures of beefed up chassis mounts for when you cut the out rigers off.

Did you get the cheap one on ebay??
DOH!

[remydog05]

I might add the last time I did bar mounts we did the same as Ball, as bit of pipe through the chassis and plates bolted to it with tabs welded back to the bar.
Sorry dont have pics but it was WWAAYYY strong!

[xedent]

remydog05 wrote:

xedent wrote:

Just got a Arb winchbar for my Sierra and just wondering what winches fit in it other than the warn ones.

Cheers

Also after some pictures of beefed up chassis mounts for when you cut the out rigers off.

Did you get the cheap one on ebay??
DOH!

No I didn't, I just don't have out rigers....

[ajsr]

you dont need outriggers, you just need to improve the ends of the chassis with crush tubes (welded) , or preferably a chassis ext and two extra holes(4 per side)