[Daz7]

Have purchased a complete Jimny power steering setup to transplant into the Sierra. After reading the posts about how it all just bolts up have came across a problem.

There's 3 mounting points on the pump bracket (I'm informed its from a 13bb) and only the top two of these line up on the Sierra block - see photos.

Whats the solution people?


I don't have the belt adjuster either, presume this will bolt on correct?

[steak_knife]

Daz7 wrote:

There's 3 mounting points on the pump bracket (I'm informed its from a 13bb) and only the top two of these line up on the Sierra block - see photos.

Whats the solution people?

Should be 4, I have both BB & B eng's here so I went for a lil walk to looky..
The bottom bolt for the BB doesn't exist on the older B block.
There also should be a smaller hole that bolt to the front of the block, if you have those 3 ( top 2 & front one ) IMO that will be enough...

Or just mark a third hole where you have a thread in the block & drill a third hole in the bracket..

[Daz7]

Thanks for that - appears I've got the older block so will have to see if I can drill a hole in the bracket for the 3rd mounting bolt.