[Mike]

i've been fixing up the sills on my sierra and i cut of the bracket on the sills and there was a bit of surface rust underneath so i ground that back but now i'm left with a few spots where the rust has eaten into the metal a bit but i cant get into them to sand grind them
what would be the best way to fix it so i can paint over it and not have to worry about it rusting anymore?

Cheers

[royce]

rust convertor and paint over it

[Mike]

i've never been able to get that stuff to work
its the only rust i've found in my whole zook and i want to do something with it so i don't have to worry about it again

[royce]

use the milky looking white night stuff, the other ones dont seem as good

[2stroker]

I have had pretty good results from a Septone product called Rustprime.

[Mike]

i found a couple pin holes that go through the panel so i'm gonna have to get it fixed

[Damo]

I had similar problems, did the passenger's side but haven't done the driver's side yet.

[Mike]

mine isn't that bad there are only 2 pin holes that have rusted through but i'm gonna have to get some one to fix it for me because i don't want to fuck the sill

[jimbo_jones]

use a die grinder to clean up the small spots