[jonno_racing]

hey guys i am trying to pull my front radius arm out and the bolt in the top of the arm is seezed in the bush..
i had this issue in my rear arms once, but the fix was to cut down the side of the bush.. that isnt going to work in this situation as i need the bush.

i have tried heating the bolt up till the bush smoked... and smashing the other end of the bolt with a hammer.. all that got me was a bent mount and fucked bolt..

any ideas? i have also tried crc etc...

Phil

[boostedbrick]

Last time i had a bolt with this issue, i just kept turning it in the bush until it broke loose.. Took a decent size breaker bar to tear the bush though.

[jonno_racing]

boostedbrick wrote:

Last time i had a bolt with this issue, i just kept turning it in the bush until it broke loose.. Took a decent size breaker bar to tear the bush though.

yeah i can turn it a good 100' but i dont want to tare the bush as i want it.

[Lockie666]

You need a bigger hammer, got any of that roost off shit? The ice stuff, heat it up then cool it down really fast. I've done it a few times.

[jonno_racing]

Lockie666 wrote:

You need a bigger hammer, got any of that roost off shit? The ice stuff, heat it up then cool it down really fast. I've done it a few times.

cant hit it any harder. have already bent the mount!

nah. not worth it for the little job.

the bolt is basicly rusted into the sleeve

[31zook]

The kingcrome freeze ya nuts off stuff ($15) then a brazing torch, to heat it up again. Otherwise buy a leafy