[Liljim]

Hi, I just got this...

http://www.jimnybits.co.uk/shop/jimny/j ... d_115.html



Not too sure what a few of the brackets are for, and it has no instructions.

If anyone has one fitted can someone put up a pic, or explain where those rectangular brackets go?

Cheers.

[steak_knife]

Run there shock's before, they did their job well...

[Benz]

nope...

but

http://www.jimnybits.co.uk/shop/jimny/j ... od_23.html

this link show a pic of one fitted.

not too clear though but you might get it

[steak_knife]

Benz wrote:

nope...

but

http://www.jimnybits.co.uk/shop/jimny/j ... od_23.html

this link show a pic of one fitted.

not too clear though but you might get it

Tis fitted wrong, will interfere with the drag link on r/h compression..
Should be chassis mounted further forward....

[Liljim]

Think I've worked it out!
The rectangular steel plates bolt around the chassis rail, took me a few goes but it looks right, and doesn't foul on lock either direction.

Still wouldn't mind seeing pic from someone on here to make sure though, that pic does look it will foul when it goes full lock, can't quite see what it's bolted to.

[Benz]

steak_knife wrote:

Benz wrote:

nope...

but

http://www.jimnybits.co.uk/shop/jimny/j ... od_23.html

this link show a pic of one fitted.

not too clear though but you might get it

Tis fitted wrong, will interfere with the drag link on r/h compression..
Should be chassis mounted further forward....

haha well there you go.

[steak_knife]

Liljim wrote:

Think I've worked it out!
The rectangular steel plates bolt around the chassis rail, took me a few goes but it looks right, and doesn't foul on lock either direction.

Still wouldn't mind seeing pic from someone on here to make sure though, that pic does look it will foul when it goes full lock, can't quite see what it's bolted to.

you set that on fitting up.....