[Bombero]

I have a mg410 Maruti (96 stockman) I need new drive shafts front and back because the slip joints are stuffed. I'm finding it hard to get a replacement. Will the nt Lwb ones fit? Or, is it possible to put new slip joints on? While I'm at it, if anyone has any to get rid of let me know.
Any help will be greatly appreciated. Thanks.

[want33s]

I have a few NT 1.3 front shafts here.
Not sure if they'll fit yours though.

[Bombero]

Have they got good slip joints? If so do you think it's possible to get them cut of and welded on my shafts for a reasonable price?

[want33s]

Bombero wrote:

Have they got good slip joints? If so do you think it's possible to get them cut of and welded on my shafts for a reasonable price?

Slip joints are fine.
Any shafting service place can replace the tube.


NT flange...

[Bombero]

If the flange is different I should be able to pop the uni and put my flanges on shouldn't I? Do they use the same uni? How much do you want for the shaft? Thanx for the quick reply

[want33s]

As far as I know you can do a half half uni joint if they are different cap sizes.
Front NT shaft... $50 delivered.
Drop one of your shafts and measure the flange.