[ajsr]

hey all
the problem
I have a coily rear diff center with a airlocker, its going into a narrow track.The problem is the the flange on the coily diff is the same as wt different pattern to narrow track.

The question
Will a wt diff end of a tail shaft mate to the upper end of a narrow track transfer end???

If so anyone in se melb want to part with a wt rear tailshaft?

The other opion is fitting a wt diff flange to the nt shaft, do these fit?Is it the same uni joint between the two?
cheers andrew

[Mike]

yes you can use half a WT and half a NT shaft and thats the easiest way to do it

[royce]

no dont do this, tailshafts are built as a single balanced unit, go swapping bits round it'll muck it up

better to fit a NT flange to the diff or shaft, same uni so it will fit