[losfer]

1.6 swift engine , comes with h4 ecu and loom , also will throw in a h5 ecu and loom. $350

Attachment:

220.jpg

1.6 single point injection setup to suit g13 or g16 8 valve . $150

Attachment:

218.jpg

1.3 alternator , almost new done less than 50km's !!! . $100

Attachment:

209.jpg

1.3 starter motor , perfect working order. $40

Attachment:

212.jpg

1.3 electronic distributor . perfect working order. $40

Attachment:

213.jpg

1.3 coil , perfect working order. $10

Attachment:

214.jpg

bolt on bullbar/ bar top . bolts on top of factory bar. free damaged front bar with bar top . $50

Attachment:

217.jpg

custom f series crank pulley . supercharge your f series engine or run another accessory!!! I made this out of 2011 grade aluminium , the aluminium cost me $80 alone and then machine work , it does require a keyway to be broached though , which any engineering shop can do for a small price. $50

Attachment:

215.jpg

also i have a 1.6 bare block bored honed and decked with new 8 valve pistons , rings and gudgeon pins , however the block has a very small crack in the water jacket only at the front left hand side of the block . the crack was only discovered after a thorough cleaning of the block. looking for $250 which is less than the price of the piston set. pictures can be taken for interested buyer.

everything located southside brisbane smaller items can be posted at buyers expense .

[Zook_Fan]

Pm sent for injection

[Llewellyn92]

whats the difference between the h4 and h5 ecu?

[losfer]

Id have to consult my partfinder which i dont have access to atm. But both ecus and looms.will run this engine....

[losfer]

Starter and injection kit sold . Open to offers on other stuff.