[ninjamoses]

Had bought these reconditioned heads a few months ago to rebuild my H25A but they are no longer needed. They are still in plastic wrap from the reconditioners. They do not include lifters or camshafts. I can take photos if need be, but just imagine a clean/freshly machined set of heads wrapped in plastic. $450 - SOLD

Also have a complete set of almost new 24 hydraulic lifters. These were purchased new from suzistore and fitted by the previous owner just a few weeks before I bought the vehicle, and have only been run for literally a few minutes due to the obvious issues with the rest of the motor. Have been sitting in tubs of oil since being removed. $100

Located in Perth.

[ninjamoses]

Heads are sold pending payment. Lifters still available.

Would like to get rid of the rest of all the old engine stuff also, preferably as one lot if possible. It is all in pieces obviously as I had stripped it down when troubleshooting. Perfect for someone who wants to build up a new motor without taking theirs off the road. Parts available are:

- Block with crankshaft
- Exhaust manifolds
- Rods & Pistons
- Old heads/Camshafts/Valve & Timing covers
- Lower/Upper Sump
- Oil pump & pickup, Waterpump
- Timing chain setup (supposedly new - had just been fitted by previous owner)

Looking for around $300 if you take the lot.
EDIT: Updated - now free, see below post.

[ninjamoses]

Want this thing out of my garage.

95% complete H25A V6 motor with 192,000km on the clock. Has a spun big end bearing - Have loosely assembled it again except for rods/pistons which are in a box, and the upper/lower sump which are off so it sits flat on the floor. As a bonus it comes with a complete intake manifold & injectors from a H27A which I have no use for.

Free to whoever wants it.

[atari4x4]

swap a LHS 26 SV620 front axle?

[ninjamoses]

Scrap motor has been claimed. Thanks all.