| Author |
Message |
sToCK_ZUK
Joined: Sun Jan 16, 2011 8:51 am Posts: 109 Location: Waterford West,Logan
|
 Posted: Thu Mar 14, 2013 10:25 pm |
|
|
Hey all
I'm having problems with my gearbox on occasions, my problem is that once you are in gear whilst driving it won't allow me to change gear at all, an happens in every gear. But if I turn the car off, I can choose any gear no problem but the moment I start the car I'm unable to select gears Its a 1991 Suzuki Sierra with a G16a engine conversion.
Any ideas on what may be causing this please reply as this is my daily driver.
Thanks
|
|
|
|
 |
Fatzook

az supporter
Joined: Sat Oct 27, 2007 11:30 pm Posts: 14977 Location: The Hills
Vehicle: Vitara, NGV
|
 Posted: Thu Mar 14, 2013 10:28 pm |
|
|
Sounds like a clutch problem to me.
Have you tried adjusting the clutch?
_________________ 2013 GV 1998 SV420 ute
|
|
|
|
 |
sToCK_ZUK
Joined: Sun Jan 16, 2011 8:51 am Posts: 109 Location: Waterford West,Logan
|
 Posted: Fri Mar 15, 2013 12:39 pm |
|
Fatzook wrote: Sounds like a clutch problem to me.
Have you tried adjusting the clutch? Yeah adjusted the clutch went good for,about a day then the problem came back
|
|
|
|
 |
tanshi

az supporter
Joined: Tue Jan 09, 2007 10:30 pm Posts: 7717 Location: Brisbane
|
 Posted: Fri Mar 15, 2013 12:56 pm |
|
|
dead clutch cable i would say
|
|
|
|
 |
sToCK_ZUK
Joined: Sun Jan 16, 2011 8:51 am Posts: 109 Location: Waterford West,Logan
|
 Posted: Fri Mar 15, 2013 1:22 pm |
|
tanshi wrote: dead clutch cable i would say Ok thanks I'll give another cable ago
|
|
|
|
 |
Fatzook

az supporter
Joined: Sat Oct 27, 2007 11:30 pm Posts: 14977 Location: The Hills
Vehicle: Vitara, NGV
|
 Posted: Fri Mar 15, 2013 1:25 pm |
|
|
What condition is the clutch fork in? It may be cracked (check around the splined hole )
_________________ 2013 GV 1998 SV420 ute
|
|
|
|
 |
sToCK_ZUK
Joined: Sun Jan 16, 2011 8:51 am Posts: 109 Location: Waterford West,Logan
|
 Posted: Fri Mar 15, 2013 6:06 pm |
|
Fatzook wrote: What condition is the clutch fork in? It may be cracked (check around the splined hole ) I'll have a check to be sure but I removed the clutch cable an the wire was all split. So replaced it with the one from stock_zuk an seems to be working Cheers
|
|
|
|
 |
Daves4wd

az supporter
Joined: Fri Aug 26, 2011 3:17 pm Posts: 1286 Location: Melbourne
Vehicle: Swb Sierra twin lock 32s 6.5s
|
 Posted: Sat Mar 16, 2013 3:50 pm |
|
|
Could be the throw out bearing is worn and bearing is seized happened to mine not long ago
|
|
|
|
 |
|