It is currently Mon Jul 13, 2026 9:13 am
Board index » Shift It And Find It » Getting rid of stuff



Post new topic Reply to topic  [ 17 posts ] 
Author Message

Offline
az supporter
az supporter
User avatar

Joined: Tue Jun 29, 2010 7:44 am
Posts: 2003
Location: Brisbane
Vehicle: 2018 DMAX

Post Posted: Mon Apr 01, 2013 2:39 pm 
Reply with quote Top  
Pick up only 4114/Kingston. More to add as i find it. Some prices negotiable.


Early vitara G16b. Unknown kms. Fresh timing belt/water pump. Small amount of smoke on start if it has sat for awhile. Heavier oil seemed to fix this... Other wise it was very strong and never let me down. Is currently mated to a Sierra box, so would suit use in a sierra(unless you have the studs to fit it in a vitara).. $400
Image
Image


5x Federal Couragia 235/75R15 on black Dynamic's. 15x7 -13. 1 new, two around 10mm tread, 2x around 9mm tread. Normal tread damage from 4wding. $450 SOLD
Image


4x Kuhmo 798 AT 215/70R15. Approx 10mm tread. Rims look like ROH Tek's or something similar, appear to be close to standard offset. The spare that came with this set is a 205/75 on stock rim, don't take it if you don't want it. $300
Image
Image


2x WT jack shafts. No play in unis, $30 each.
Image


1x WT front drive shaft, no play in unis. $40
1x G16b extractors, no flange. Bashed to fit into a sierra. Surface rust. $70
Image
Image


VL engine mount $10
3x transfer mounts $10
G16b Denso coil/ignitor, removed from running motor. $40
Complete g13b dizzy. $30
G16b dizzy bare. $30
Image


Narrow body starter G16b . $50 SOLD
4pin 22 spline center. $30
Image


12x hub bolts with con washers. $20
1LTR switch, 2xWT flanges. No rear flange. Was rebuilt at some point, it drove well
but condition is unknown. $150
Image


ABS plastic flares to suit Sierra, they covered 31's on 15x7 - 13's. $150 SOLD
Image

Good fuel tank with ODA guard, tank has drain plug. $100 Tank is gone, bash guard only $50
Image

Alloy bar, unknown brand. Damage as pictured. Bar/indicators only. $75
Image
Image
Image


No pictures for this stuff

1x NT 1.3 transfer/transfer handbrake in GC, is fitted to my daily driver and works very well. $200

Baleno G16B. 150, 000. Head has been recoed recently. Sump setup for sierra. Will be sold without manifolds/dizzy. Right angle drive distributor with vitara cam, uses vitara dizzy. Valve clearances need doing. Fresh head gasket. $550

2" OME comfort rears. 3 leafs in one pack, 4 in the other. Was used in the front of a sierra with RUF. $75

2" Spring pack. Custom mains(around 1060mm long from memory, longer than EFS rears), with fillers from assorted packs. 4 leafs + main in each pack. Enough here to mix and match into a nice set of rears. $75

Loneranger long range tank for sierra. 70ltr, some small dents. Required removal of old rear mounts from chassis when fitted to a NT. $150

1.3 sierra gearbox. Runs quite, syncros on 2nd/4th are getting old. $75

1.3 sierra gearbox. Input bearing is noisy. Shifts really well. $75


Some prices negotiable!


Last edited by boostedbrick on Fri Apr 12, 2013 4:11 pm, edited 5 times in total.
 Profile  

Offline
User avatar

Joined: Tue May 25, 2010 10:56 am
Posts: 1051
Location: north brisbane

Post Posted: Mon Apr 01, 2013 4:00 pm 
Reply with quote Top  
Pm sent about vl mounts and jack shaft

 Profile  

Offline
az supporter
az supporter
User avatar

Joined: Sun Jan 10, 2010 10:30 pm
Posts: 735
Location: Scenic Rim, Qld
Vehicle: 1995 SWB Sierra TinTop

Post Posted: Mon Apr 01, 2013 7:01 pm 
Reply with quote Top  
PM'd about flares :)

 Profile  

Offline

Joined: Sun Aug 26, 2012 2:13 pm
Posts: 34
Location: Lynbrook
Vehicle: 89 w/t sierra

Post Posted: Thu Apr 04, 2013 9:00 am 
Reply with quote Top  
Would the fuel tank be too big to ship down to Melbourne? Happy to pay freight

 Profile  

Offline
az supporter
az supporter
User avatar

Joined: Tue Jun 29, 2010 7:44 am
Posts: 2003
Location: Brisbane
Vehicle: 2018 DMAX

Post Posted: Thu Apr 04, 2013 9:06 pm 
Reply with quote Top  
josh green wrote:
Would the fuel tank be too big to ship down to Melbourne? Happy to pay freight



Ill take some measurements and get a quote. What postcode?

 Profile  

Offline

Joined: Fri Feb 12, 2010 10:30 pm
Posts: 284
Location: Brisbane

Post Posted: Fri Apr 05, 2013 5:59 am 
Reply with quote Top  
Pm sent

 Profile  

Offline

Joined: Sun Aug 16, 2009 11:30 pm
Posts: 240
Location: brisbane

Post Posted: Fri Apr 05, 2013 2:31 pm 
Reply with quote Top  
do u still have the bar?

 Profile  

Offline
az supporter
az supporter
User avatar

Joined: Tue Jun 29, 2010 7:44 am
Posts: 2003
Location: Brisbane
Vehicle: 2018 DMAX

Post Posted: Fri Apr 05, 2013 2:38 pm 
Reply with quote Top  
Still got it

 Profile  

Offline

Joined: Sat Dec 11, 2010 10:03 pm
Posts: 2261
Location: Gold Coast
Vehicle: Daisy

Post Posted: Fri Apr 05, 2013 4:16 pm 
Reply with quote Top  
Is that starter in good order?
If so I'll take it, the one that was on my engine (being from a baleno) isn't the freaking same :(

Do you want to post or prefer pickup, can send you the $ and pickup in a few weeks if that works?

 Profile  

Offline
az supporter
az supporter
User avatar

Joined: Tue Jun 29, 2010 7:44 am
Posts: 2003
Location: Brisbane
Vehicle: 2018 DMAX

Post Posted: Fri Apr 05, 2013 5:25 pm 
Reply with quote Top  
Starter was pulled from a working motor, I had issues with it at one point but a good internal clean has given me 6months of trouble free starting. I would prefer pickup, willing to hold it if its payed for.

 Profile  

Offline

Joined: Sat Dec 11, 2010 10:03 pm
Posts: 2261
Location: Gold Coast
Vehicle: Daisy

Post Posted: Sun Apr 07, 2013 6:42 am 
Reply with quote Top  
Pm me your details and ill send through the dosh, if you also let me know pickup addy ill work out when I can get there and let you know.

 Profile  

Offline
az supporter
az supporter
User avatar

Joined: Tue Jun 29, 2010 7:44 am
Posts: 2003
Location: Brisbane
Vehicle: 2018 DMAX

Post Posted: Thu Apr 11, 2013 5:23 pm 
Reply with quote Top  
Bump and new stuff down the bottom of the post.

 Profile  

Offline

Joined: Sat Apr 06, 2013 10:33 pm
Posts: 16
Vehicle: Jx sierra

Post Posted: Thu Apr 18, 2013 11:36 am 
Reply with quote Top  
Pmed about springs

 Profile  

Offline

Joined: Mon Mar 14, 2011 1:42 am
Posts: 77
Location: Sunshine Coast

Post Posted: Thu Apr 18, 2013 9:03 pm 
Reply with quote Top  
Where abouts in Brizzy are you? Might try and organise some one to pick up the transfer case and fuel tank bash plate if you still have them

 Profile  

Offline
az supporter
az supporter
User avatar

Joined: Mon Jul 06, 2009 11:30 pm
Posts: 1017
Location: brisbane QLD
Vehicle: 91 swb vit 5"lift 31's.

Post Posted: Thu Apr 18, 2013 9:32 pm 
Reply with quote Top  
you thinking of selling those spotlights by any chance??

 Profile  

Offline

Joined: Fri May 25, 2012 10:26 am
Posts: 41
Location: Toowoomba
Vehicle: 1988.5 tin top

Post Posted: Fri Apr 19, 2013 11:41 am 
Reply with quote Top  
Messaged

 Profile  

Offline
az supporter
az supporter
User avatar

Joined: Tue Jun 29, 2010 7:44 am
Posts: 2003
Location: Brisbane
Vehicle: 2018 DMAX

Post Posted: Sun Apr 21, 2013 11:29 am 
Reply with quote Top  
Been away for a few days, just replying to everyone's PM's..


holden26 im at Kingston. transfer and guard still here. Which transfer did you want?

 Profile  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 17 posts ] 

Jump to:  


Who is online

Users browsing this forum: No registered users and 38 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
Untitled Document


Untitled Document


Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group :: Style based on FI Subice by phpBBservice.nl :: All times are UTC + 9:30 hours