[Bazooker]

The coils on the Jimny I have, 98 G13b, are aftermarket. I have had a few issues but because the current ones are not OME the loom was cut to accommodate. The original three pin plugs are gone so I have to manufacture new ones.

Now I know that one wire is the signal br/blue, one is earth and one is continuous power. What I don't know is where these wires go into the coil..

Now I know this is a little hard to explain and harder because of my inability to post a picture. Holding the coils verticle you can see three horizontal plugs. Left middle and right. Now if one of you whizz kids can tell me which is which I can go from there.

Help is appreciated as always.