[Xtreme]

I ordered Joes front end axle upgrade for my 99 Jimny. As a few other posts show Joe has been a bit hard to get hold of to check some information. I wondered if anyone had ordered the upgrade for the front from Joe as well and what I wanted to check is if these samurai CV will fit.

http://wheelersoffroad.com/product/empi ... -cv-joint/

The Axles I received from Joe are 25 spline one end and 26 spline the other and I was told that the samurai empi 26-26 spline cv are what I need. But I dont know if there are different lengths or anything else to check for.

Does anyone know if this will work, or has anyone done the upgrade?

I am also told to run a Vitara hub and stub assembly on the front end (I will also be running this on the full float rear so I only need one set of bearings and spares to do all corners) with a Grand Vitara Drive Flange. Will the Jimny rotor still mate up with the vitara hub on the front end? (I am going to be running pintara wagon calipers on the rear conversion and understand that will fit the Vitara rotors?)

[Skippy]

They don't even know they have them

I got a shipping quote and they said about $100 but they said they had to bring them "in house" so the quote was a rough price.

If you have better luck than me let me know as i'm chasing a set