[taurean]

Hi all,

i am currently in the process of removing my gearbox to replace the clutch.

im having quite a bit of trouble sliding it out as it seems to be really tight as if something is stopping it.
i dont think ive missed any bolts anywhere as its pulled away from the motor with about a 5-10mm even gap all around.

maybe ive missed something? or is it just being stubborn and will take a bit of fiddling to release.
it just seems too tight and i dont really wanna break anything.


anything i should look at?

cheers

Taurean

[gregwatkins75]

Clutch cable off?
All 6 bolts out?
Gear sticks out?
Cross mount out?
Speedo cables off?
Tail shafts out?

There's two wire looms at to off grearbox to unhook which had me for a bit.....ones reverse light cur it other is pollution crap...

There's nothing hard to it.....just have to make sure it's all unhooked first.

[redvitara]

What about the pressed steel cover that closes off the front/bottom of the bell housing. It's bolted to the bell housing but the flywheel is between it & the bell housing.
Silverfox1111

[taurean]

Cheers for the replies, yeah all of the above has been done, and ive checked it over a few times.

i have got my mechanic friend coming to give me a hand tomorrow, he should be able to get it sorted.

ive had enough haha