[evilmonkey]

Hi guys

I've just been given a seat of mint vt Calais seats..
So I figured what better car to put them into then a stockman lol

Has anyone had luck fitting Commy seats?

Cheers

[HarryHoudini]

...you mean fit one and use it as front bench seat,you'll have to cut a hole for the handbrake.

[evilmonkey]

I actually meant the two front seats..

I take that as they're too wide then?

[Gwagensteve]

Yes, it's been done.

No, I'm not sure ts a good idea.

[HarryHoudini]

evilmonkey wrote:

I actually meant the two front seats..

I take that as they're too wide then?

Yeah,a bit big,i'm surprised someone has done it as you would be too close to the steering wheel even if you could squeeze them in lenghtways.

[MrRocky]

Only adviseable for a midget, width may also be an issue

[evilmonkey]

Well I'm only 5'8", so might give it a closer inspection next weekend

Maybe it will work if I only put the drivers side in...

Cheers for the help lads

[rexhunta]

S13 Silvia/ 180sx seats have done me well, I'm about the same height as you. Last pair I picked up were from a 180sx, velour tiger trim and was $20 for the pair.

[buzbox]

I went with Baleno seats and even then, they're a bit of a squeeze. I definitely sit a bit higher, lucky i'm a short bastard.

[greenzook89]

buzbox wrote:

I went with Baleno seats and even then, they're a bit of a squeeze. I definitely sit a bit higher, lucky i'm a short bastard.

I found the same. I'm 5'11. I definitely wouldn't want them to sit any higher.