[Che]

I got a throttle body i'll eventually pop on top of my LPG setup, just wondering what this bypass bit is all about. Is this an idle flow bypass or is it a feed to go to some sensor? Hopefully the green arrows are dark enough to make sense of

[royce]

yes

[JrZook]

That would go to the idle up air bypass solenoid. Block it off when you mount it. SHouldn't have any issues

[Che]

OK cool, I have the adaptor plate made, was just wondering if I need to get the dremel out and accomodate for this.

So the throttle butterfly is supposed to sit slightly open at rest to allow for an idle flow?

[steak_knife]

che_guitarra wrote:

OK cool, I have the adaptor plate made, was just wondering if I need to get the dremel out and accomodate for this.

So the throttle butterfly is supposed to sit slightly open at rest to allow for an idle flow?

yes....

[JrZook]

If it has the bypass blocked off then yes it will need to be slightly open. Fab up a throttle stop so you can adjust your idle speed.

[Che]

It's got an adjuster screw already, but as it's set the butterfly is 100% closed at rest. Easy fix, cheers guys

[11_evl]

butterfly should sit slightly open so it doesnt jam or give a stiff feel when opening