[shane1992]

Hey guys, what should I expect when doing this? Are the bearings hard to get off? I have a bearing puller will that do the job?

[sogone]

Ya need a press. Or a grinder and a hammer. I always just use a grinder then a cold chisel and hammer.

[shane1992]

What exactly do you grind, As much of the bearing as you can with out hitting the axle?

[zukmeista]

You need to grind the bearing and the collar. They will probably get hot enough that they will just slide off anyway.

[zooky08]

Grind as much as u can then use a cold chisel nd hit inside the crack of the sleeve. Thee sleeve should eventually crack and slide off. Bearing is a bit harder as you can't really get ion there witth a grinder.

Another hint make sure you put the backing plate on first before you press on the new bearings

[shane1992]

Are they hard to press back on?

Thanks for the help!

[royce]

http://auszookers.com/index.php?name=Ne ... cle&sid=17

[shane1992]

royce wrote:

http://auszookers.com/index.php?name=News&file=article&sid=17

i looked hard for a thread!
Obviously didnt look hard enough