| Author |
Message |
liamhh

az supporter
Joined: Sat Apr 30, 2011 6:02 am Posts: 38 Location: Whyalla
|
 Posted: Fri Dec 02, 2011 4:56 am |
|
|
|
 |
Bruce

az supporter
Joined: Sun Jun 11, 2006 11:30 pm Posts: 4003 Location: Brisbane
|
 Posted: Fri Dec 02, 2011 4:59 am |
|
Well I would pull the axles out, then remove the diff and then we will all know.
I'm beting side / spider gears or pinion gear or crown wheel.  ooh could be bearing. That's about all that is in there so I must win.
_________________ [quote="royce"] I wouldnt mind insulating my rear
|
|
|
|
 |
Scrawny

I live here!
Joined: Tue Jan 29, 2008 10:30 pm Posts: 10528 Location: Brissie
Vehicle: Popemobile
|
 Posted: Fri Dec 02, 2011 5:34 am |
|
|
Spider gears are fine. Run the car in gear (2WD) up on the axle stands and stick ya head under (with or without camera) and tell us where the noise is coming from.
|
|
|
|
 |
liamhh

az supporter
Joined: Sat Apr 30, 2011 6:02 am Posts: 38 Location: Whyalla
|
 Posted: Fri Dec 02, 2011 6:02 am |
|
|
The noise is coming from the diff pumpkin and towards the end of the passenger side axle tube.
|
|
|
|
 |
Scrawny

I live here!
Joined: Tue Jan 29, 2008 10:30 pm Posts: 10528 Location: Brissie
Vehicle: Popemobile
|
 Posted: Fri Dec 02, 2011 6:03 am |
|
|
Pull it out and have a look then. If it's damaged then you gotta get it out anyway
|
|
|
|
 |
zooky08

az supporter
Joined: Fri Nov 27, 2009 10:30 pm Posts: 3426 Location: imbil/gympie. qld
Vehicle: 03 Jimny
|
 Posted: Fri Dec 02, 2011 7:12 am |
|
|
Carrier bearings
_________________ 03 Jimny 30 km2s 75mm lift f&r locked winch
|
|
|
|
 |
joeblow
Joined: Sat May 10, 2008 11:30 pm Posts: 3273 Location: melbourne
|
 Posted: Fri Dec 02, 2011 7:56 am |
|
zooky08 wrote: Carrier bearings
ahhhh.....no.
That is 1.03 minutes I will never get back........
Pull things apart and it will be obvious what is wrong.
_________________ builder of custom road legal zooks......and stuff.
|
|
|
|
 |
Bruce

az supporter
Joined: Sun Jun 11, 2006 11:30 pm Posts: 4003 Location: Brisbane
|
 Posted: Fri Dec 02, 2011 8:00 am |
|
joeblow wrote: zooky08 wrote: Carrier bearings ahhhh.....no. That is 1.03 minutes I will never get back........ Pull things apart and it will be obvious what is wrong.
That's what I was trying to say 
_________________ [quote="royce"] I wouldnt mind insulating my rear
|
|
|
|
 |
zooky08

az supporter
Joined: Fri Nov 27, 2009 10:30 pm Posts: 3426 Location: imbil/gympie. qld
Vehicle: 03 Jimny
|
 Posted: Fri Dec 02, 2011 11:01 am |
|
I didn't even watch the clip 
_________________ 03 Jimny 30 km2s 75mm lift f&r locked winch
|
|
|
|
 |
whincup

az supporter
Joined: Sat Apr 17, 2010 11:30 pm Posts: 1588 Location: Gracemere, QLD
Vehicle: '94 suzuki maruti
|
 Posted: Fri Dec 02, 2011 8:38 pm |
|
when both wheels are in the air and the cars in gear and you have an open centre (no locker), when you spin one wheel the other should spin the opposite direction.
liamhh wrote: The noise is coming from the diff pumpkin and towards the end of the passenger side axle tube.
have you checked wheel bearings?. while the cars on the stands still with the wheel in the air, grab both the top and bottom of the wheel and try to wiggle it , see how much play it has...
|
|
|
|
 |
liamhh

az supporter
Joined: Sat Apr 30, 2011 6:02 am Posts: 38 Location: Whyalla
|
 Posted: Sat Dec 03, 2011 1:45 am |
|
|
Found the problem, diffs fine it's a stuffed wheel bearing making all the noise. My moment of stupidity wandering why my wheels wear spinning of the ground in gear. Should of done the bearing when I replaced the axle seals.
Thanks for the help
Cheers
Liam
|
|
|
|
 |
|