It is currently Thu Jul 30, 2026 5:50 pm
Board index » Talking About Stuff » Suzuki Talk



Post new topic Reply to topic  [ 19 posts ] 
Author Message

Offline
az supporter
az supporter
User avatar

Joined: Fri Nov 27, 2009 10:30 pm
Posts: 3426
Location: imbil/gympie. qld
Vehicle: 03 Jimny

Post Posted: Tue Nov 09, 2010 11:45 pm 
Reply with quote Top  
my car never goes when i want it to :( . it is literally a piece of shit. makes me so frustrated

the car was working pefect the other day. i put new oil in it. as well as a new oil filter. now its blower alot of smoke, spark plugs are always going black, my guess is need new rings or valves. some thing like that

after all that ive discovered, theres sometimes spark, some times not at all, coil pack maaby? ive checked dizzy, clean all point, rotor button, new leads, clean plugs. still no change

when it does wanna go, when its cold it only starts when u let go of the key, WTH :? but when its fairly hot it starts normal, some times when you let go still. strange to me :?

dis morning when i went to start it, to see if there was a change. nothing :( but now the burnt gases and smoke are coming out of carby, nothing is coming out of the exhaust its cold as and the carby is boiling hot

has my engine finally past away. please help my lump of crap :D

thanks Aaron

 Profile  

Offline
User avatar

Joined: Tue Mar 09, 2010 10:30 pm
Posts: 1645
Location: Ipswich

Post Posted: Wed Nov 10, 2010 12:13 am 
Reply with quote Top  
Get a 1.6 EFI... Problem solved.

 Profile  

Offline
az supporter
az supporter
User avatar

Joined: Fri Nov 27, 2009 10:30 pm
Posts: 3426
Location: imbil/gympie. qld
Vehicle: 03 Jimny

Post Posted: Wed Nov 10, 2010 12:17 am 
Reply with quote Top  
ive got a 1.6 carby

_________________
03 Jimny 30 km2s 75mm lift f&r locked winch

 Profile  

Offline
User avatar

Joined: Tue Mar 09, 2010 10:30 pm
Posts: 1645
Location: Ipswich

Post Posted: Wed Nov 10, 2010 1:15 am 
Reply with quote Top  
efi is better ;) :D

 Profile  

Offline
az supporter
az supporter
User avatar

Joined: Fri Nov 27, 2009 10:30 pm
Posts: 3426
Location: imbil/gympie. qld
Vehicle: 03 Jimny

Post Posted: Wed Nov 10, 2010 1:44 am 
Reply with quote Top  
sure is, would be less problems. ill turn it to efi later on down the track :). so no one can help. ill just figure it out my self

thanks

_________________
03 Jimny 30 km2s 75mm lift f&r locked winch

 Profile  

Offline
User avatar

Joined: Tue Aug 08, 2006 11:30 pm
Posts: 5517
Location: Holland Park
Vehicle: Awesome!!

Post Posted: Wed Nov 10, 2010 1:46 am 
Reply with quote Top  
zooky08 wrote:
the car was working pefect the other day. i put new oil in it. as well as a new oil filter. now its blower alot of smoke, spark plugs are always going black, my guess is need new rings or valves. some thing like that


What color smoke? Black?

_________________
Lil Foot!
http://tiny.cc/gtsw1

 Profile  

Offline

Joined: Sun Nov 01, 2009 10:30 pm
Posts: 1286
Vehicle: Suzuki

Post Posted: Wed Nov 10, 2010 1:49 am 
Reply with quote Top  
zooky08 wrote:
sure is, would be less problems. ill turn it to efi later on down the track :). so no one can help. ill just figure it out my self

thanks


Give it some time, You only posted 2 hours ago, People do work and don't live on the forums during the day..

 Profile  

Offline
az supporter
az supporter
User avatar

Joined: Fri Nov 27, 2009 10:30 pm
Posts: 3426
Location: imbil/gympie. qld
Vehicle: 03 Jimny

Post Posted: Wed Nov 10, 2010 1:55 am 
Reply with quote Top  
JrZook wrote:
zooky08 wrote:
the car was working pefect the other day. i put new oil in it. as well as a new oil filter. now its blower alot of smoke, spark plugs are always going black, my guess is need new rings or valves. some thing like that


What color smoke? Black?


bluey/grey

 Profile  

Offline
User avatar

Joined: Sat Mar 24, 2007 10:30 pm
Posts: 1052
Location: MORNINGTON. VIC

Post Posted: Wed Nov 10, 2010 3:02 am 
Reply with quote Top  
put in too much oil?

 Profile  

Offline

Joined: Sun Apr 11, 2010 11:30 pm
Posts: 706

Post Posted: Wed Nov 10, 2010 3:07 am 
Reply with quote Top  
I'll post some helpful info tonight, i can't now i'm at work =P
But dw, its EASY FIX

 Profile  

Offline
az supporter
az supporter
User avatar

Joined: Fri Nov 27, 2009 10:30 pm
Posts: 3426
Location: imbil/gympie. qld
Vehicle: 03 Jimny

Post Posted: Wed Nov 10, 2010 4:01 am 
Reply with quote Top  
BAZZOOK wrote:
put in too much oil?
its not quite full, so i havnt over filled it

 Profile  

Offline
az supporter
az supporter

Joined: Tue Jul 03, 2007 11:30 pm
Posts: 1350
Location: stuck in a hole. not off road, just deception bay.
Vehicle: snotbox, 84 LWB sierra 1 litre

Post Posted: Wed Nov 10, 2010 6:16 am 
Reply with quote Top  
zooky08 wrote:
BAZZOOK wrote:
put in too much oil?
its not quite full, so i havnt over filled it


going by the dipstick, or the oil cap? :lol:

 Profile  

Offline
az supporter
az supporter
User avatar

Joined: Fri Nov 27, 2009 10:30 pm
Posts: 3426
Location: imbil/gympie. qld
Vehicle: 03 Jimny

Post Posted: Wed Nov 10, 2010 6:23 am 
Reply with quote Top  
mrw82 wrote:
zooky08 wrote:
BAZZOOK wrote:
put in too much oil?
its not quite full, so i havnt over filled it


going by the dipstick, or the oil cap? :lol:
dipstick :D

 Profile  

Offline
User avatar

Joined: Sun Apr 06, 2008 11:30 pm
Posts: 184
Location: Brisbane

Post Posted: Thu Nov 11, 2010 1:09 pm 
Reply with quote Top  
when you say it only starts when you let go of the key do you mean it only fires then? that the starter works normally..

if this is happening check the wiring to your coil, there should be a wire that is energized when you are cranking and then it get its feed when the key returns to the run position.
A worn out ignition switch will cause this behaviour and is usually hard to trace as its intermittent..

the hot carby thing sound weird, is the heat from the heater hoses running up to the carby choke or from somewhere else?

 Profile  


Post Posted: Thu Nov 11, 2010 10:19 pm 
Reply with quote Top  
i know its not the problem, but what sort of fuel you running aswell?

  

Offline
az supporter
az supporter
User avatar

Joined: Fri Nov 27, 2009 10:30 pm
Posts: 3426
Location: imbil/gympie. qld
Vehicle: 03 Jimny

Post Posted: Fri Nov 12, 2010 12:45 am 
Reply with quote Top  
the car fires up when i let go the key and it returns to run. so im thinking its some thing to do with the coil or barrel. starter motor is working fine

heater hoses are blocked off, not the original carby. there was like gases or smoke coming out of the carby enough to blow my filter off. carby was really hot, exhaust was cold.

did a oil change again after 5 days. oil that came out of the engine was black after 5days. change oil again still blowing smoke, im guessing its new valves and valve seating time :(. or i think i need to do valve clearances. one off my rockers are very loud. is this causing the grey smoke out of the exhaust cos one of the valve isnt closing properly :s

toeragz: i dont know what fuel. my car isnt on the road atm, so my mum went and got me it. mosly likely it'll be E10

_________________
03 Jimny 30 km2s 75mm lift f&r locked winch

 Profile  

Offline
az supporter
az supporter
User avatar

Joined: Mon Dec 11, 2006 10:30 pm
Posts: 34842
Location: East Radelayed
Vehicle: SV420+SV620 Vitara's

Post Posted: Fri Nov 12, 2010 12:51 am 
Reply with quote Top  
is the cat/exhaust damaged or collapsed?

_________________
You're just hating because you don't understand

 Profile WWW  

Offline
az supporter
az supporter
User avatar

Joined: Fri Nov 27, 2009 10:30 pm
Posts: 3426
Location: imbil/gympie. qld
Vehicle: 03 Jimny

Post Posted: Fri Nov 12, 2010 12:57 am 
Reply with quote Top  
atari4x4 wrote:
is the cat/exhaust damaged or collapsed?


i wouldnt have a clue sorry, i was thinking of doing a exhaust upgrade very shortly though.

 Profile  

Offline
az supporter
az supporter
User avatar

Joined: Fri Nov 27, 2009 10:30 pm
Posts: 3426
Location: imbil/gympie. qld
Vehicle: 03 Jimny

Post Posted: Fri Nov 12, 2010 3:01 am 
Reply with quote Top  
just took the exhaust manifold off. looks like cylinder 3 is shot. theres black oil coming out off cylinder 3 exhaust port. started it up and it only blows grey/blue smoke out of exhaust port. taking a cylinder pressure test this arvo

does any one know what pressure it should be for g16a

_________________
03 Jimny 30 km2s 75mm lift f&r locked winch

 Profile  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 19 posts ] 

Jump to:  


Who is online

Users browsing this forum: Google [Bot], Google Adsense [Bot] and 271 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
Untitled Document


Untitled Document


Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group :: Style based on FI Subice by phpBBservice.nl :: All times are UTC + 9:30 hours