[warrior64]

I have seen someone post a pic of their divider they made up out of marine ply.The divider is for a soft top to make the front cab as "secure" as can be and reduce noise and wind bufffeting from the rear .
Does anyone have specs for the odd shape of the area that is behind the seats and where the divider goes? I was thinking of getting a large sheet of butchers paper and scribing it on as a template ?

[douglasgiersch]

IMO grab some cardboad (try the back of safeway or coles and just ask the workers for a big bit) cardboard will be able stand up and hold its wieght unlike butchers paper which would just flop around, will make it alot easier. I am shortly going to make one for my swb sierra and will use cardboard.

[warrior64]

Tried plastic sheeting = Bastard.
Tried card board = Semi bastard ,but a basic template .

At least ive got a rough template now but will have to trim up a few practice ply sheets before a nice tight fit is found ! Once I have a fited rear divider, I will fit a perspex window into it so I can see the trafic im holding up !

[zooky08]

viewtopic.php?f=14&t=19730&start=30

some thing like this, first pic on page.
They did put the window in upside down though.

[SierraDan]

Or put it that way to make better use of available vision with the window that way.

[got_bar_work]

3mm mdf sheet is the bomb for templets
U can cut it with a knife, saw, drill it, sand it
Its strong but can be bend

[coily96]

I used cardboard double thickness.
viewtopic.php?f=14&t=19191&hilit=marine+ply
Mine was half the height you want to make up, but u get the idea.