[burls]

I seem to remember someone enlarging a balljoint eye to fit a larger balljoint to a sierra draglink or something
Is there a tool I can buy to increase the taper and is it easy enough to do?

[want33s]

I have a pair of Sierra swivel hubs already reamed out to take Toyota tie rods.
PM me if interested.

[Fatzook]

The tool is called a tapered reamer.

But you can't fit larger Tie rod ends to the suzuki arms. You need to make new arms as well.

[burls]

It's not for the tie rod nor the knuckles it's for the draglink.
I have pajero ps box that has a balljoint so my plan was to make a draglink with an eye at each end screwed into a nice piece of 4130
Your thoughts?

[Fatzook]

What do you mean by "an eye at each end"?

[burls]

The normal drag link on a sierra has one eye end that fits on the balljoint on the tie rod and a ball joint end that fits into the pitman arm. I need a set up that has two eye ends ans the pitman arm on the steering box has a ball joint. Hope that makes sense

[Fatzook]

It does.

But I don't think you can buy those ends. They are cast.

[burls]

That is my dilemma
Either I have to rework the ones I have or find another pitman arm that fits the pajero steering box