[zooky08]

Has any one came across this problem were g16b hits the brake hard lines coming out of the brake cylinder. Running a 2 body lift. Body still has to go towards passenger side 10mm.

[want33s]

What engine mounts are you using? Commonwhore?

[zooky08]

Looks like stock on ps and benT on ds. Engine was pulled from another sierra

[stockman]

I had to adjust the hardline when doing my g13bb conversion, but don't recall having to do it with my Baleno g16b conversion (slightly taller motor).

[Rossco]

I have the same setup and mine doesn't hit. There is some trickery going on somewhere, I'll check mine out in the morning.

[azzas15]

I have plenty of space on mine I'll check again when I get home

[BenT]

Check that the cast engine mount brackets that bolt to the block are from the 1300. The 1600 ones are a different height and might be causing the engine to lean over.

Ben

[azzas15]

Here is a pic of mine not sure why yours is so close

[zooky08]

Yours is from a baleno right? My g16b is from a vitara. Might be different. You running body lift at all?

[azzas15]

Yes my G16b is from a Baleno