[thorno]

hi all, I am chasing the 3 small banjo bolts that hold the 3 oil feed lines onto the side of the crank case, (not the larger ones at the top on the cylinder block) or any ideas to where I can source them along with the rubber inserted flat washers, I tried copper washers and had air bubbles then over tightened the bolt n snapped it....... any help would be great thx

[tanshi]

I have some second hand I could post you

[greyghost]

i think there is a solution for the washers, from memory you can use ones from a Suzuki outboard with oil injection (can't remember the model though)
this is the only source for the washers with the rubber seal in the middle like original, that i know of. i'm happy to be proved wrong though

[thorno]

thx for your help, I will check with our local Suzuki dealer thx, tanshi I will pm you thx

[thorno]

bump, need these to get a note out of my rebuild thx. anyone













bump, need these to get a note out of my rebuild. thx anyone!!!!!

[jamiec]

I have them just missing one washer. I may be able to find one more washer to complete the set.

Let me know if you still need these?

Thanks Jamie

[thorno]

jamiec, you have a pm, thx

[thorno]

big thx to jamiec for helping me out with these bolts