[magnat]

The Keyless entry is stuffed on the XL-7, the little buttons on the controller have come unsoldered and I don't have the skills to re-solder something that small.

What are the options??

[fordem]

Either replacement remotes if you can find them (try ebay) or install an aftermarket alarm system with remote entry and wire it to the existing power locks - it might work out less expensive than the remotes.

[magnat]

So you can get an Aftermarket one installed to do the same job??

I shoved my head under the dash but I could only find a thing that had Mitsubishi Electrics over it and a frequency.. Not sure if that was it..

Well after pulling some numbers off the thing I found out I was looking at the Immobilizer unit...

So where the hell is the central locking one ???

[Farkyard]

Mines been stuffed for ages magnat. If its just a cracked solder joint then appliance tech should be able to sort you for the remote.

[Farkyard]

And further to that I have never been able to find the unit for mine. I have a thread somewhere else bout mine but nothing's ever worked despite a number of suggestions.